Description
Conversion kit high-speed cutter Wohlenberg from monitor tube chassis system 85/86/90 to LCD chassis
The following steps are necessary for the conversion to LCD:
1. disassemble monitor chassis
2. remove picture tube and circuit board (ventilate tube properly, dispose of).
3. function keys, alpha keyboard remains (if available)
4. new LCD chassis, loosen nuts and lift off frame
5. insert the chassis from the rear, attach the front frame and screw tight.
6. pull off the AMP plug from the CPU, eject the contacts.
7. set voltage at potentiometer to 12 volts
Press in new pins according to the enclosed pin assignment.
9. pinch off the crimp contacts of system 86/90 and push them into the pin header.
10.plug on AMP connector system 85 / pin header for system 86
11.for system 86/90, tap voltage at switching power supply (bypass terminals)
12.settings of the LCD monitor is made by three keys on the board
